The Electric Piano Forum

General => The Wurlitzer Electric Piano => Topic started by: seanny_keys on May 07, 2019, 08:09:22 AM

Title: Bottom Capstan Screw
Post by: seanny_keys on May 07, 2019, 08:09:22 AM
Hello my fellow electric keys enthusiasts,

I am trying to understand the proper setting for the bottom capstan screws on the 200a. Based on the manual it seems like the the bottom capstan screw should be set so each key has 1/32" of wiggle at the tip of the key when resting (Lost Motion Traveling Depth).
(https://ibb.co/mysyfWj)
Am I understanding this correctly?

Does anyone have a good technique for setting this? E.g. measuring each key's traveling depth with a ruler vs. adjusting to the right feel.

Thanks,
Seanny
Title: Re: Bottom Capstan Screw
Post by: pianotuner steveo on May 07, 2019, 09:36:13 AM
It does not have to be perfect as long as it is close, and there is a little lost motion. If it's too high, the hammer/whip assembly will start to rise up. If that happens, back the capstan down again until there is a tiny gap between the tip of the jack and the whip felt. If it's too tight, the jack won't always return to it's starting position again.

This normally doesn't need much adjustment unless someone has messed with it. The other capstan (letoff adjustment) is far more critical.
Title: Re: Bottom Capstan Screw
Post by: seanny_keys on May 07, 2019, 10:39:24 AM
Okay great makes perfect sense to me, thanks!

I think I may have one or two keys towards the bottom end that are too tight and not falling back into position.
Title: Re: Bottom Capstan Screw
Post by: funkylaundry on May 22, 2019, 05:17:40 AM
What I usually do is I hold the hammer in place with a finger so it doesn't move and then I lightly press the key with my other hand and see how much the key moves before it's obstructed by the hammer. I don't actually measure it - I just make sure that each key has a "little bit of wiggle" before the hammer moves anywhere.
Title: Re: Bottom Capstan Screw
Post by: DocWurly on May 28, 2019, 11:19:29 AM
The important thing is that the fly resets when you stop depressing the key.  So, watch the base of the fly when you slowly release the key back up.  It should "pop" up, back into place, at the end of the key's returning.  On the other hand, you don't want excessive lost motion--just enough to allow that to happen.

If there isn't enough lost motion, rapid playing of a note will result in the hammer not hitting the reed every time, after the first play.
Title: Re: Bottom Capstan Screw
Post by: pianotuner steveo on May 29, 2019, 06:52:38 AM
BTW, Fly = jack. Nobody calls the jack the fly anymore, but that is what it is called in the service manuals.
Title: Re: Bottom Capstan Screw
Post by: DocWurly on May 30, 2019, 10:25:42 AM
thank you, Steve-o!