Don't forget to read the forum rules.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - TooManyKeys

Hey folks, I'm fairly new to both the forum and electronics. Has anyone had success replacing the original incandescent power light on a Wurlitzer 720b or 140b with an LED? I would value any input! I have followed the Vintage Vibe installation following their guide: cut out the 18k resistor at the terminal strip and jumpered the first two tabs, ran the grey wire from the 4-pin harness to the positive lead on the LED, negative to the red wire from the volume pot and grounded the negative to the braided shield on the 4-pin harness.
The LED does not turn on, and this configuration seems to leave my amp permanently on. Any thoughts?
Thanks in advance!
Hey everyone,
I have a 726b (spinet model of 146b), the student model counterpart of the 720b (spinet 140b). The LDR vibrato assembly is present on the amplifier which is otherwise identical to a 720b. I have carefully cut out the "umbilical cord" wiring and self/ensemble switch and used clip leads to wire up potentiometers to test the vibrato circuit but haven't been very successful so far at enabling the vibrato.
The 140b schematic specifies a 100k ohm linear taper potentiometer for vibrato depth control, though some users on the forum have had luck with 50k linear taper or 100k audio/log taper for a smoother sweep. I have tried all three, with the same result: the vibrato is only present when the pot is turned no less than to the max, and even then is very weak at best, though I can observe the bulb flashing.
Could this be a result of drifted resistors throwing off the circuit that governs the bulb? Or any other culprit?