Messages

Never mind.  I figured it out.

When I bought it, the speakers had been taken out.  I'd like to put then back in.  Can someone show me how they are wired?  The left speaker has a white wire attached to a three pronged plug.  Pretty obvious where that goes.

But where does the red wire attach?

I am a nube at this, so be kind and forgiving.  Your patience is greatly appreciated.

Thanks in advance.

Here is another one...

http://portland.craigslist.org/wsc/msg/4312316042.html

Thanks.  You have confirmed what I thought.  There is no pre-amp in mine.  Therefore, I must have a 200 with a 200a lid.

I agree.  Rob A's results look good.  I hope to have similar results.

Thanks for the response.  So...If the lid is from a 200a, how can I be sure of the rest of the keyboard?  the plate on the bottom says 200.  If it was a 200a, would the model number indicate that?  Are there other indicators as to which model I have.

What I am getting at is that I think the keyboard is a 200, but someone put on a 200a lid.

Thoughts?

Can someone tell me if I have a 200 or 200a?  The lid has the decorative screws to hold the speakers, but the plate on the bottom says 200.  And I noticed that the lid did not close all the way because of the speakers mounted to the lid.

Which model has the speakers mounted to the amp board, and which has it mounted to the lid?

Thanks, Rob A.  I thought I had seen your post in the past, but could not find it.

Any thoughts on how to deal with the scratches?

Thanks.  I'll try a bit of Armor All.  I don't imagine that will do anything for the scuff marks, will it?

I recently purchased a 200.  The black top is scuffed and in need of some new life.  Can anyone tell me the best way to restore it?  I looked through the forum and didn't see anything on this.  Sorry if I missed it.

Is there anything I can do about the scuff marks?

Can I use a rattle can of Vinyl Dye?

What about Amor All?

Thanks!