Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - funkminster

Pages: [1]
The Fender Rhodes Electric Piano / Re: Torn out wood around t-nuts
« on: March 15, 2019, 02:24:33 PM »
Thanks for the advice. Intuitively, taking the piano apart sounds harrowing, but it's good to hear it's not that bad. Found a video from Vintage Vibe that should help.

Will let you all know how it goes!

The Fender Rhodes Electric Piano / Torn out wood around t-nuts
« on: March 14, 2019, 01:14:44 PM »
Just a bit of background: I bought a 1973 Rhodes Mark I Stage model in good condition a couple years ago. It didn't come with the legs or brackets, but I thought: how hard/expensive can they be to buy and install? Haha! What followed was a long, accidental journey into vintage instrument restoration.

As it turns out, while everything above the legs is in great shape, and the piano sounds great, it looks like someone dragged the piano across the room too many times and did some damage to the wood in the cabinet that holds the legs in place.

After some time, I've pieced together the legs, the brackets, the bolts, the nuts, and all of the varied pieces of hardware. Only to find that a few of the t-nuts that hold in the bracket bolts in the cabinet were torn out, along with some of the wood around them.

So, now I'm faced with some choices on how to repair this ... so I can just freakin' get some legs on this thing.

I can either try to fix it without taking off the keyboard by working something up through the leg hole (I can get the t-nuts in this way, there's just nothing there for them to grab). Or I can attempt to remove the keyboard, which I think would give me access to the t-nuts?

Once I'm there, I've come up with the following options:

1. Fill the gap in the wood with epoxy and sink the t-nuts into that before it dries.
2. Cut out some dowels and wedge these into the broken wood. Hammer the t-nuts through the dowels in an attempt to "recreate" the original set-up.
3. Going through the leg hole, use something tacky but not permanent (hot glue? clay?) to fill the wood gaps just so the t-nuts will stay in place and I can screw in the bolts. This options means that in the long-run, the nuts won't be gripping anything besides the bolt.

Any suggestions on the best approach here? I'm a bit over my head here, so thanks in advance for any advice!


Pages: [1]