News:

Available now!.. "Down the Rhodes: The Fender Rhodes Story" (book & documentary) More...

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - fozziemusic

#1
I found out that my 200a has some seriously wrong voltages on the reed bar (it appears that only one of C30, 31 and 34 is working) - with readings starting about 80 volts and dropping to 52V after measuring for a few seconds - not sure if that is a sort of loading effect of my DMM but I'm nowhere near 150V. Other voltages seem to be ok-is - the +/- 22.5V is 24.5V in my amp, other voltages are spot on or similarly off.

While I'm at it to replace those caps, I would like to change the big cans too, they are still the original ones. I'm not that familiar with electronic parts though - it is clear to me that I should order 2200 uF radial caps, but I'm not sure of the voltage rating (it says 'WV 35' on them - is that 35V?). I would expect higher for power supply caps - but I guess they are after the transformer so maybe that is correct. I'd like to be sure though.
And are there physical dimensions to take into account (diameter, lead pitch, ..)? Any pointers or specific replacement part details would be highly appreciated.

One more question: I need a replacement 1.5A 32V main fuse, but I can only find higher voltage (250V) rated ones. In my simple mind fuses are about current so it should be OK - but again I would like to double check.

I'm aware of discussions on whether or not to rebuild the amp - but I would like to give it a shot myself and keep things original. Any guidance on the above questions would be highly appreciated!

Last edit: apologies if this question would fit better in the Parts, Service, Maintenance & Repairs section. Moderators please feel free to move this.