Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - DAtkinson

Pages: [1]
1
Wanting to fix the annoying plastic clack that is coming from a bunch of keys, basically all the black keys, whose plastic caps have become slightly loose from their metal frame. Has anybody had to do this? Do you just rip the cap off entirely and re-glue from scratch, or try to inject the glue without removing the cap? What adhesive did you use?

D

2
Hi all

I'm getting ready to freshen up my Mark II from 1980 - plastic hammers, wooden keys. Have a series of questions before I take the plunge and make the parts order from VV. I know some of these have been asked before, but hopefully this thread will be useful for anybody doing a late Mark 1 or an early Mk II restoration.

Like many Mark 2 owners, I've never loved it as much as the Mk 1 that I played in high school, so I am definitely looking to get that warmer barkier sound, less of the bright modern tone, although I do prefer the action of the 2.

- no-brainer is replacing tone bar grommets (pic1)

- am I correct that I do not need to attend to the key pedestals? They have a built-in bump, and while the felts have a very slightly worn groove at the rear, they look otherwise ok. (pic2)

- am I correct that my damper felts are still good? (one of them in the photo looks floppy, but while angled it still feels firm) (pic3)

- the big one: hammer tips! (pics 4 and 5)
Mine have some grooves and pits, so I am assuming that I should change my tips. I've read here and there that using older-style tips, either square or graduated, might get me closer to the sound I've been looking for. However, I've also read that you shouldn't go from graduated to non-graduated, as it screws up with the strike line. So...
 - should I get new tips?
 - should I stick with graduated tips, and rely purely on voicing to get the sound I want?
 - or should I try a different tip? I know VV sound very excited about their new angled tip set, but I'm worried about moving to non-graduated tips

- finally, I'm pulling out my hair trying to assess my tines. I suspect a few might be dying, but with my old grommets I can't be sure whether it's the tine or something else. Anybody have some insight there? Related to this, I noticed that there were multiple harp mounting holes, which allowed me to try a couple of different strike line positions. Playing around with this was game-changingly impactful, but didn't get me any closer to knowing if I should replace any of my tines.

You can hear the piano here: https://youtu.be/CtjcEj3wWBU

In this video, which I made to document this project for myself and some colleagues, I mull over all the above questions and take a closer look. If anybody has the spare time to glance, it would help me immensely, and hopefully others who are working with this era of pianos.

Cheers to all of you, very excited to become part of this community!

3
Other Keyboards & Software Synths / Hammond transformer inside D6
« on: July 08, 2020, 10:48:05 AM »
Hi all

1st post, working on a D6 which I picked up a decade ago.

Trying to figure out what is going on inside. Looks like somebody has done some hobbyist work, and there is a Hammond transformer wired into the power supply.

I've attached a pic, can anybody tell me what is going on in here?

Thanks,

David


Pages: [1]