Messages

By trimming the female end of http://www.amazon.com/Coleman-Cable-15-Feet-Outdoor-Extension/dp/B00103Z1UU with an utility knife, I was able to power up the Wurlitzer.  After waiting a few minutes to warm up, it plays just like it used to.

Thanks for all the suggestions!

The cord that came with my 140B is not original but fits perfectly.  It's not round, even though the socket on the amp chassis is.  It's rectangular, and labeled Sony so I am guessing it's from a piece of stereo equipment or something like that.

So if you're looking for a new cord, don't assume it has to be round, just look for something with the correct receptacle type that is small enough to fit in the amp socket.  If you find a cord that will work but the plug is a little big, you might be able to carefully trim the rubber molding a bit to help fit it up.

Thanks for the tip!

I have never had a problem finding a cord to fit one of the old Wurlitzers, but I have not tried in a while. Are you not in the U.S.? I have had to do this three times, and always found one in a store.

Yes, I am in rural USA.

I might have an original cord for the 140B laying around. I would highly recommend putting in a modern IEC connection. You can put it in the same hole as the original, just drill two new holes to mount the new connector. You can attach the safety ground wire to one of the bolts holding down the connector (with a terminal lug), and make sure to to fasten the bolt tightly!!

Thanks for reply.  Knowing the specs for the original cord (round end) could make it easier to find a suitable replacement.

I would recommend putting in an IEC connector if you have the amp out. I'm not sure where that cord is anymore, the last time I saw it was over a year ago. Maybe I threw it out.  a standard cable and IEC connector costs about $5.

The amp inside the piano would need to be removed in order to replace the plug, eh?  I'd have to look at the complexity such a process. 

I haven't found an IEC connector.  However, I found http://www.cablestogo.com/categories.asp?cat_id=8810001 while searching.  Decent selection, but no round plugs.

You can use a three prong extension as long as it fits into the hole.

I attempted to trace the hole around the Wurli 2-prong plug.  Looks to be 1-1 1/8" diameter.  The plug on the 3-prong extension cord I have is 1.25" X 1.5"; far too large.

I might have an original cord for the 140B laying around. I would highly recommend putting in a modern IEC connection. You can put it in the same hole as the original, just drill two new holes to mount the new connector. You can attach the safety ground wire to one of the bolts holding down the connector (with a terminal lug), and make sure to to fasten the bolt tightly!!

Thanks for reply.  Knowing the specs for the original cord (round end) could make it easier to find a suitable replacement.

I wont touch such a classic but... you may find cheaper getting a new standard computer socket for less than a buck and replacing the original... you can even borrow one from an older computer power suply and as long as you dont drill new holes it could be reversed later

Thanks for reply.  A computer socket may end up the solution.  I'm not too handy.  Years ago, I had a spare (new) computer power supply.  Wonder where else such a socket could be found?

hope depot and other stores like that often sell replacement ends for extension cords, you could put one of those on any power cable.

something like this: http://www.homedepot.com/Electrical-Electrical-Outlets-Plugs-Plugs-Connectors/h_d1/N-5yc1vZbodr/R-202664520/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053

I have no idea what the socket looks like though, so this is just a guess.

Thanks for reply.  Those are interesting; however, this is a 2-prong style.  It looks like all the connectors listed are 3-prong.  A lot more selection at Home Depot than locally!

You need to find an extension cord with a round end that will fit into the hole, that is not as hard to do as it sounds. Trace the opening and take the tracing to a store that has a large variety of cords.

Thanks for reply.  I checked at the few businesses in this town of less than 10,000 for a round plug, with no luck.

First time post & overwhelmed by the wealth of knowledge here.

I have a Wurlitzer 140B that's been sitting uncovered in storage for 10 years.  It worked when stored.  Along the way, the power cord (brown, IIRC) was lost.  A 3-prong type of computer power cord doesn't fit, nor does a modern extension cord.  The circular opening is rare, as power cords go.

I'd like to get it going again.  It's really too heavy & not my preference of touch & tone.  The main reason I kept it is the full size keys.

Ideally, I'd like an instrument that's light & portable, with a piano touch & tone.  The Casio Privia PX-330 or CDP-100 might fit the bill, based solely upon dealer's web sites.  I've heard from professionals that Korg is good.  This is for light amateur home use.  Portability is key, as I move between apartments across the US in a car frequently.  Budget is low.  I'll get a cord & use the Wurli as-is, or trade/sell it for more suitable replacement.  I will not have 2 pianos at once.

Any pointers on how to cheaply get the Wurli going would be appreciated.  Also, thoughts on my goal of moving to a different instrument are welcome.  I think this will be an online purchase, as the 2-stoplight town here has no music store.

Thank you!