Hi all,
I picked up a chopped 203 today at the local music store for only $400. Pretty happy about it all around. Problem is that it's definitely got some electrical issues and my electrical knowledge consists of being able to wire a basic 12v circuit.
It turns on and actually will produce sound through the aftermarket 1/4" jack, so long as the volume is turned all the way up. However it's very distorted.
Looking at the amp, I see two wires from the power transformer that aren't connected to the circuit board, and I also see a green clip on a single capacitor.
My first thought is just to solder the connections from the power transformer and give it a whirl, but as stated, I have no real electrical knowledge and don't know how to do this without possibly shocking myself. That's my biggest worry. I'm a huge DIY guy and I can figure most anything out, but for most things I get a lot of chances to fail and redo and learn from my mistakes. Won't be a whole lot of learning if I get shocked to death the first time I try lol.
Any ideas on what the best course of action is? Do I need to read electronics 101 before I start working on this thing? Or is it relatively safe?
https://streamable.com/8ckr2f
I picked up a chopped 203 today at the local music store for only $400. Pretty happy about it all around. Problem is that it's definitely got some electrical issues and my electrical knowledge consists of being able to wire a basic 12v circuit.
It turns on and actually will produce sound through the aftermarket 1/4" jack, so long as the volume is turned all the way up. However it's very distorted.
Looking at the amp, I see two wires from the power transformer that aren't connected to the circuit board, and I also see a green clip on a single capacitor.
My first thought is just to solder the connections from the power transformer and give it a whirl, but as stated, I have no real electrical knowledge and don't know how to do this without possibly shocking myself. That's my biggest worry. I'm a huge DIY guy and I can figure most anything out, but for most things I get a lot of chances to fail and redo and learn from my mistakes. Won't be a whole lot of learning if I get shocked to death the first time I try lol.
Any ideas on what the best course of action is? Do I need to read electronics 101 before I start working on this thing? Or is it relatively safe?
https://streamable.com/8ckr2f